Installation Instructions
Positioning module
Conductor rail program 0832, C-rail,
Console, ProShell
MV0800-0015a-EN
www.conductix.com
translated document
Page 10 of 23
3.2.1
Clipping in the band holder
3.2.1.1
Installation in support profile
Clip the band holder onto the C-rail:
Fig. 13: Clipping in the band holder
Fig. 14: Band holder after clipping in
3.2.2
Inserting/clipping the positioning band profile into the band holder
CAUTION!
Danger of cutting!
The following activities may result in injury due to cutting due to carelessness.
Wear suitable protective clothing such as gloves and work safety shoes.
The positioning band roller profile can "spring open" when unlocking. Avoid danger of injury
when unlocking the positioning band roller profile!
CAUTION!
Make sure that the positioning band profile is correctly aligned in the lane!
Before inserting/clipping in the positioning band profile, check the alignment of the positioning band
in the lane!
If necessary, turn the positioning band in the lane: The positioning band must be aligned
with the reader and the start code must be on the correct side of the aisle (see chapter 6.3)
Fig. 15: Clipping in the positioning band profile and clipped-in positioning
band profile
Fig. 16: Inserting the positioning band profile
After installation of the band holders and the positioning band profile, the positioning band profile must be easily and freely movable
in the X direction in order to be able to set the desired positioning range and to avoid displacement when the temperature changes.
Pre-drill the positioning band profile on both sides as shown in the illustration and then screw it to the tensioning unit.
