BRIDGEGUARD PLUS
TM
MANUAL
16
SECTION 4 - INSTALLATION
4.5 Sensor Calibration
4.5.1 STOP and SLOWDOWN Distance Detection Settings
4.5.1.1 Make sure that the sensor and the reflector are properly mounted and make sure the visible laser light can be seen on the
reflector before setting range detection.
4.5.1.2 Setting the range detection distances will require movement of the crane to the desired STOP and SLOWDOWN distances.
4.5.2 Setting up STOP distance detection
1. With the sensor mounted to the crane, move crane to the STOP distance point.
2. Press and hold (it will take approximately 5 seconds) the “SELECT” pushbutton until “Q1 Near” LED turns ON.
3. Press “SET” pushbutton; “Q1” and “Q2” LEDs should flash twice simultaneously indicating that the setup was successful. If “Q1”
and “Q2” LED’s do NOT flash, repeat this step.
4. Press and hold “SELECT” pushbutton for at least 6 seconds to exit setting up STOP distance setup mode. “Q1” and “RUN” LEDs
should stay on with the crane at the STOP distance.
4.5.3 Setting up SLOWDOWN distance detection
1. With the sensor mounted to the crane, move crane to the SLOWDOWN distance point.
2. Press and hold (it will take approximately 5 seconds) the “SELECT” pushbutton until “Q1 Near” LED turns ON.
3. Press select until “Q2 Near” LED light turns ON (Hint: press “SELECT” 3 times).
4. Press “SET” pushbutton “Q1” and “Q2” LEDs should flash twice simultaneously indicating that the setup was successful. If “Q1”
and “Q2” LED’s do NOT flash, repeat this step.
5. Press and hold the “SELECT” pushbutton for at least 6 seconds to exit setting up SLOWDOWN distance setup mode. “Q2” and
“RUN” LEDs should stay on with the crane at the SLOWDOWN distance.
6. Move the crane back and forth a couple of times to verify relays are triggering at the correct distances.
Figure 4-6
1. Q1 Indicator Light
6. Q2 near Indicator Light
11. Q1 Indicator Light
2. Q2 Indicator Light
7. Q2 far Indicator Light
12. Q2 Indicator Light
3. Run Indicator Light
8. Slow Indicator Light
13. Run light/Satus Indicator Light
4. Q1 near Indicator Light
9. Select Push Button
5. Q1 far Indicator Light
10. Set Push Button
11
2
10
7
12
3
4
5
6
9
8
Q1 Q2
run
Q1 near
Q1 far
Q2 near
Q2 far
slow
ObSB
ObSB
fast
select
set
13
1
Содержание BridgeGuard Plus
Страница 19: ...BRIDGEGUARD PLUSTM MANUAL 19 NOTES...
