Conductix-Wampfler BridgeGuard Plus, Руководство по сборке, установке, эксплуатации и обслуживанию

Страница: 11 / 20

BRIDGEGUARD PLUS
TM
MANUAL
11
3.4.3 Window (Wnd) program
1. Push and hold SELECT button for 3-4 seconds to enter TEACH MODE. The top LED (Q1 NEAR) will light up.
2. Place the object and the minimum detection distance to the sensor. Press SET and the distance between the object and the
sensor is saved as a switch point. The LEDs for Q1 and Q2 will flash in sync twice. When the minimum detection distance is
reached, the relay goes from a “1” state (active, green light) to a “0” state (inactive, red light) to a “1” state (active, green light)
and triggers the SLOW feature.
3. Push the SELECT button to switch to Q2 FAR. Place the object at the maximum detection distance to the sensor. Press SET
and distance between the object and the sensor is saved as a switch point. The LEDs for Q1 and Q2 will flash twice. When the
maximum detection distance is reached, the relay goes from a “0” state (inactive, red light) to a “1” state (active, green light) and
triggers the SLOW feature.
4. To close out of the sensor’s function, press and hold SELECT for 5 seconds. Also, not operating the sensor for 5 minutes will
lock-in functions.
3.4.4 Object between Sensor and Background (ObSB) program
1. Remove all objects between the sensor and the background.
2. Push and hold SELECT button for 3-4 seconds to enter TEACH MODE. The top LED (Q1 NEAR) will light up.
3. Push the SELECT button two more times so the Q1 NEAR and Q1 FAR LEDs are both lit.
4. Push the SET button. The Q1 and Q2 LEDs will flash twice, then the Q2 LED stays lit. This means the background is set. When
an object is placed in the path of the sensor, the relay goes from a “0” state (inactive, red light) to a “1” state (active, green light).
When the object is removed from the path of the sensor, relay goes from a “1” state (active, green light) to a “0” (inactive, red
light).
5. To close out of the sensors function, press and hold SELECT for 5 seconds. Also, not operating the sensor for 5 minutes will lock
in functions.
SECTION 3 - OVERVIEW
3.4 Function
3.4.1 Q1 and Q2 are used as switching outputs, the following modes are available.
• Window (Wnd)
• Object between Sensor and Background (ObSB)
3.4.2 To Unlock Sensor
1. Push and hold the Select button for 3-4 seconds to enter TEACH MODE. The top LED (Q1 NEAR) will light up.
2. Press the Select button. This will cycle through the Q1 and Q2 relays.
3. To set up the sensor speed cycle to SLOW. There are 5 speeds, and the LED will blink 1-5 times according to the selected speed.
Push the SET button until the proper speed setting is achieved.
4. To close out of the sensors function, press and hold SELECT for 5 seconds. Also, not operating the sensor for 5 minutes will lock
in functions.