58
Connection…
Fail
Do_IDE_Cmd:
wait DRQ
The IDE interface is waiting for DRQ signal to go off in
command phase.
Do_IDE_Cmd
ERROR ? !
An error (?) occurred in IDE interface. Use Disk Check
to identify faulty disk channel.
IDE_ISR: wait
Master Int
IDE interface is waiting for an interrupt from a disk.
IDE_ISR: wait
IDE Busy off
IDE interface is waiting for disk to be free.
IDE_ISR:
status ?
IDE disk drive current status (?)
IDE_ISR: wait
DRQ
To wait for disk drive to turn off DRQ in Interrupt phase.
IDE_ISR: DRQ
ON
Indicates DRQ is not free in Interrupt phase.
DISK: status ?,
error: ? !!
The status (status ?) and error (error: ?) returned by the
disk based on the ATA-2 Specification.
DISK: #X
type=?, blkno=?,
resid=?
The disk (x) failed to respond to a request by the
controller (type=?). The block number (blkno=?) where
the request failed. The remaining sectors (resid=?)
DISK: Initialize
#? ERROR!
The disk (x) was unable to be initialized by the controller.
Possible bad disk.
DISK: #x is
off-line!
Disk number (x) failed and was removed from the RAID
configuration.
DISK: #x not
installed!
The disk (x) is not detected by the controller. Possible
bad disk.
DISK: #x
ERROR
status ? !
The disk (x) caused an error. The status (?) returned by
the disk per ATA-2 Specification.
ERROR: Not a
hard disk!
The controller does not recognize the device installed.
ERROR: Disk
parameters
ERROR!
The controller was unable to read the disks parameters
(Cylinder, Heads, Sectors, Multi-Sector). Possible bad
disk.
Error Message
Explanation
ERROR: No
multi-sector
mode!
The disk does not support the ATA-2 multi-sector transfer
function. The disk is an older IDE disk.
ERROR: IORDY
not support!
Disk does not support IORDY. Possible older IDE disk
that does not support ATA-2 Specification. Must replace
disk.
DISK: #? Remap
area overflow !
The area used to re-map bad sectors is full.
DISK: #? Blk
no: ? is
remapped.
Block number (?) is detected as a bad sector and has
been re-mapped.
DISK: #? Remap
area is empty!
No re-map sectors are available while the controller
detected bad sectors.
Modem time-out! The modem did not respond to the page or FAX
notification request. Modem may be turned off or not
