3.4.1 Installing a SO DIMM Module
Please follow the below procedures to install SO-DIMM module.
1. Power off the system and disconnect the power connector.
2. Locate the SO DIMM socket on the controller board.
3. To install a memory card, hold the memory card with the edge connector side
towards the slot. The edge connector is divided into two unequal lengths. With the
controller box facing you, the shortest edge is closest to the front of the box, the
longest end is nearest the back.
4. Hold the card at a shallow angle (about 25 degrees) and insert the edge connector
into the connector slot. The “gold teeth” of the edge connector should no longer be
visible when the card is fully inserted.
5. Press the module downwards so that it is flat inside the compartment. You can hear
an audible click as the latches of the connector lock the card in place.
20
To remove a module that is already in place, unhook the latches on either side of the
module. Put the card in vertical position., and lift it out of the socket.
