Condair RH 1.8, Инструкция по установке и эксплуатации

Страница: 40 / 68

40 Operation
6.5 Decommissioning
To take the Condair RH steam humidifier out of operation, proceed as follows:
1. Press the On/Off switch on the Condair RH (>2 s) until the cylinder status LED blinks blue. Any steam
production in progress is stopped. The drain valve opens and the steam cylinder is drained.
2. Wait until the steam cylinder has emptied completely (approx. 11 minutes).
WARNING!
Burn hazard!
The water in the steam cylinder can be up to 100 °C .
For this reason: Before opening the unit, wait until the steam cylinder has been completely drained
and cooled down sufficiently so that there is no longer any risk of burns (wait at least 20 minutes).
3. If maintenance work is to be carried out on the Condair RH or the steam humidification system:
• Close the filter valve (or the shut-off valve) in the water supply line.
• Disconnect the Condair RH from the power supply: Pull out the mains cable (RH 1.8) or switch
off the electrical isolator in the power supply line (RH 3.6) and secure the switch in the off posi-
tion to prevent it from being switched on unintentionally. Signaling the environment that work is
being carried out on the unit.
DANGER!
Danger of electric hazard!
After switching off the unit switch, voltage is still present inside the control compartment of the
Condair RH. It is therefore essential to disconnect the Condair RH from the power supply
before opening it .
• Switch off the HRV ventilation unit and secure it against unintentional start-up.