Concept2 VR3105 Скачать руководство пользователя

Страница: 41 / 93

VR3105

R - right side

brush

L - left side
brush

Dust container and filter grid

(clean regularly)

1. Press the button and pull the dust container

backwards.

2. Open and clean the dust container.

Cleaning the filter grid

(clean regularly)

1. After prolonged use, remove the filter grid, foam filter

and HEPA filter.

2. Clean the removed filter grid. Rinse the foam filter and

HEPA filter under water.

3. Wipe the individual parts and let them dry freely.
4. After drying, gradually install them in the correct order:

grid - foam filter - HEPA filter.

Filter grid

(coarse filter)

Button

Filter cover

Foam filter

HEPA filter

Note:

•

Rinse the filter grid with clean water and do not add
any detergent.

•

Do not clean the filter grid with a brush or fingers.

•

Allow the filter grid to air dry for at least 24 hours.

•

Replace the filter grid every 3 to 6 months.

Sensors

(clean regularly)

Clean the sensors with a soft cloth as follows:
1.  Clean the sensors along the wall to the right.
2.  Three cliff sensors at the bottom of the appliance.
3.  Infra-red anti-collision sensor in front of the appliance.
4.  Protection against electric shock and docking station

contacts at the bottom of the appliances (turn off the
appliance during cleaning).

5. Docking station signal transmission area.

Cliff sensor

TOF sensor

Charging

contact

Sensors

(clean every month)

Anti-collision

sensor

Infra-red

charging sensor

Base charging

contacts

Signal

transmission area

LDS laser range-

finder

Anti-collision sensor

for radar sensor

Battery
•

The appliance is equipped with high-performance lithium-ion batteries. To maintain battery performance, keep the
appliance charged every day.

•

If the appliance is not used for a long time, turn it off and store it properly. Charge it at least every 3 months to prevent
damage to the batteries due to excessive discharge.

Firmware update

Use the mobile app to update the firmware. If new firmware is detected, update as prompted. When updating the
firmware, the battery level should be ≥50 %, so the appliance should be placed in the docking station.

COMMON PROBLEMS

Problem

Remedy

The robot cannot be

started

•

If the battery is low, place the robot in the docking station and align it with the board
contacts, the appliance will start automatically (if the robot is completely off, it can
start automatically after a while).

•

Do not use the appliance if the ambient temperature is below 0 °C or above 50 °C.
Use at 0-40 °C.

The robot cannot be

charged

•

Move the robot off the station, make sure the docking station indicator light turns on,
and make sure both ends of the docking station power adapter are properly connected.

•

In case of poor contact, clean the docking station contact points and charging
contacts on the robot or turn the side brush to the side.

The robot cannot be

recharged

The robot is too far from the docking station, place it near the docking station and try
again.

Abnormal behaviour

Restart the appliance to factory settings. To restart, press and hold both buttons for 10-
15 seconds until the appliance switches off.

Unusual noise is heard

during use

The main brush, side brush or wheel may be wrapped with foreign objects, turn off the
robot and remove foreign objects.

Cleaning ability is
reduced or dust is

dropping from the