Concept2 SVK6550ss, Руководство пользователя

Страница: 90 / 108

90
EN
SVK6550ss / SVK6550wh
Note:
1. Never hold a pressed burner knob for more than 15 seconds. If the burner does not ignite within
15 seconds, release the pressed knob and turn it to the OFF position, wait for and then try again.
2. In case of power failure, the burners can be lit by carefully using a match.
Protection against gas leakage without flame
It is a thermoelectric cell located near the burner, which monitors the flame on the basis of heat radiation and
if the flame accidentally goes out, it closes the gas supply of the specific burner.
If a flame accidentally goes out, turn the respective knob clockwise to the OFF position. Wait one minute and
reignite the burner.
OPERATING INSTRUCTIONS
Operation
The display will show “0:00” when connected to the mains. The current programmer time must be set.
Failure to set the current time will prevent the oven from operating.
The display is equipped with finger-operated sensors at marked spots. Each change of the sensor settings is confirmed
by an acoustic signal. It is necessary to keep the surface of the sensors clean.
Ignition of the burners by a lighter together with a rotary knob
• press the rotary knob of the selected burner up to a noticeable resistance and turn it to the left to the “big flame”
position,
• hold until the gas is ignited,
• after igniting the burner flame, release the pressure on the knob and adjust it
Setting the current time
After switching on or restarting after a power failure, the display shows a flashing 0.00:
• press and hold the
MENU
sensor (or the </> sensors at the same time) until the symbol appears on the display and
the dot below the symbol flashes,
• within 7 seconds, set the current time using the sensors </>.
After approx. 7 seconds from the end of the time setting, the new data will be saved and the dot under the symbol (4)
will stop flashing.
You can change the time later by pressing the sensors </> at the same time, when the dot below the symbol (4) starts
flashing, you can change the current time.
Caution!
The oven can be switched on when the symbol (4) appears on the display