EN
73
MNV6560
2. Disconnect the dishwasher from the water supply.
3. Demount the supply hose and drain water from the dishwasher. A shallow tray, e.g. a sink tub, may be used for collecting
the drained water.
4. Reconnect the supply hose to the dishwasher.
5. Remove the fi ltering system in the dishwasher‘s bottom and dry the remaining water in the drain e.g. with a sponge.
Some maintenance tips
• After every use, turn off the water supply, and leave the dishwasher‘s door slightly open to prevent dampness and odour
from accumulating.
• Before maintaining and cleaning, disconnect the supply cord from the electric socket.
Do not use rough tools or hand-washing sponges. They might scratch the surface. Use a wet cloth soaked in water with
detergent.
• When leaving your apartment for a longer period of time, run a dishwashing program with the dishwasher empty; once the
program is over, disconnect the power supply cord from the electric socket, close the water tap, and leave the door slightly
open to prevent dampness and odour from accumulating inside. The ajar door also prolongs the life of the door seals.
• If the appliance is to be relocated, keep it in the vertical position during transfer. If this is impossible, turn and move it onto
its back side.
• Impurities accumulated around individual seals are one of the sources of odour. Check them and wipe with a wet cloth if
needed.
Fig. 12
Hole for power supply hose and drain hose. Can be
placed on the left or right side.
Dimensions CF are the dimensions
of the front panel (see Figure 13)
DISHWASHER CONNECTION AND ASSEMBLY
General
Standard and built-in dishwashers installed additionally as free-standing appliances must be protected from overturning.
They should, for example, be screwed to the wall, or placed under a compact worktop fi xed to cupboards.
The dishwasher has to be expertly connected to ensure its proper operation. The data for water input and output and
electric parameters must correspond to the data indicated in the technical parameters or assembly instructions.
Preparation for installation
The built-in dimensions are shown in Figure 12. Leave a minimum space of 50 mm around the open door.
