EN
71
MNV6560
Program information
The stated data applies under normal conditions.
Major diff erences may occur due to:
• Diff ering amounts of dishes,
• The incoming water temperature,
• The water mains pressure,
• The adjacent temperature,
• The voltage tolerance in the mains,
• By deviations in the dishwasher‘s operation (e.g. the temperature, water quantity etc.).
Dishwashing procedure
1. Open the dishwasher‘s door
2. Check and, if needed, add salt or the rinse aid.
3. Pull out, fi ll, and push in racks in an orderly manner.
4. Put the relevant amount of dishwashing detergent into the corresponding compartment of the container.
5. Open the water tap up fully.
6. Turn on the dishwasher by pressing the main switch (1). All symbols and indicator lights will be illuminated for a
moment.
7. Select the required program by repeatedly pressing the P pushbutton (6). The expectant duration of the program
shows itself on the display.
8. If a delayed dishwashing start is needed, repeatedly press the delayed-start pushbutton (4) in order to set up the
required time of delay (up to 12 hours).
9. Close the dishwasher‘s door with slight pressure until it locks into place. The preset program or the delayed start
countdown will commence.
10. Once the program is over, the dishwasher signalises its end with a beep.
11. Open the dishwasher‘s door, and turn the dishwasher off by pressing the main switch (1).
CAUTION! Be careful when opening the dishwasher. A large volume of steam might release when the door is opened.
12. Close the water mains tap.
13. Hot dishes are very fragile. It is recommended to wait for about 15 minutes before removing your dishes to let them
cool down.
14. Remove the dishes from the lower rack fi rst, then from the upper racks, to prevent water dripping from the dishes
placed above onto those below.
In case the selected program is to be changed:
a) If the program has not started yet, select another program or press the main switch pushbutton (1) – the dishwasher
turns off and the preset program is cleared from the memory.
b) If the program is already running, press the main switch pushbutton (1) – the dishwasher turns off and the preset
program is cleared from the memory.
Note:
If you decide to change the selected program, check to see if there is any dishwashing detergent in the
container, or if it has already been used, and if required add more before starting a new program.
In case additional dishes are to be placed in the dishwasher when a program is already running
1. Slightly open the dishwasher‘s door; the running program will stop. Wait until spray arms stop moving.
2. Add dishes into the dishwasher and close the door. The running program resumes after a couple of seconds.
