43
ETV6260
EN
3. Put the unit on the edge of the cabinet and run the power cord through the rear wall of the cabinet so that its
plug is accessible after installation.
4. Push the unit carefully to the selected place in the cabinet. Be careful not to squeeze the power cord.
5. Attach the unit to the cabinet by screwing four screws in the holes in the front wall. The holes can be seen after
opening of the door (see Fig. 6).
6. Plug the supply cable in the wall outlet.
Fig. 6
REPAIR & MAINTENANCE
Bulb replacement
The bulb of the internal space lighting is special, with high thermal resistance (25 W, 300°C).
For the replacement proceed as follows:
• Pull out the power cord from the mains outlet or switch off the circuit breaker of the unit’s mains outlet.
• Unscrew the covering glass and replace the bulb with a new one of the same type.
• Screw the covering glass back in place.
WARNING!
The customer may only perform the bulb replacement. Any extensive maintenance or repair that requires access
to the inner parts of the product must be performed by an expert service centre.
Removal
To uninstall the unit, it is important to proceed correctly:
1. First, unplug the power cord from the mains (pull out the plug or switch off the circuit breaker).
2. Remove the attachment screws.
3. Slide out the unit and at the same time pull out the power cord carefully.
