Conair Thermolator TW, Руководство пользователя

Страница: 7 / 116

UGH025-0504 Thermolator TW Series
I
NTRODUCTION
1-3
We design equipment with the user’s safety in mind. You can
avoid the potential hazards identified on this machine by
following the procedures outlined below and elsewhere in the
User Guide.
ATTENTION:
R
EAD THIS SO NO
ONE GETS HURT
WARNING: Improper installation,
operation or servicing may result in
equipment damage or personal injury.
This equipment should be installed, adjusted,
and serviced by qualified technical personnel
who are familiar with the construction, operation
and potential hazards of this type of equipment.
All wiring, disconnects and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. A properly sized
conductive ground wire from the incoming
power supply must be connected to the chassis
ground terminal inside the electrical enclosure.
Improper grounding can result in personal injury
and erratic machine operation.
Do not operate the equipment at power levels
other than what is specified on the the equip-
ment serial tag and data plate.
WARNING: Electrical shock hazard
This equipment is powered by three-phase
main voltage, as specified on the machine seri-
al tag and data plate.
Always disconnect and lock out the incoming
main power source before opening the electrical
enclosure or performing non-standard operating
procedures, such as troubleshooting or mainte-
nance. Only qualified personnel should perform
procedures that require access to the electrical
enclosure while power is on.
CAUTION: Hot surfaces
Surface temperatures inside the Thermolator
can exceed 250°F (121°C). Always allow the
unit to cool to below 100°F (38°C) before open-
ing, servicing or disassembling the unit.