7:5
UGG050-0517
S Series
Advanced
(E)
(F)
(H)
(G)
(J)
(A)
(B)
(D)
(C)
A C C E S S
L E V E L
1
←
P A S S W O R D . : * * * *
→
Level 1
S E T
A B S
M O D E
←
T I M E D
R E V
→
S E T
R E V
M O D E
←
R E V
→
Level 1
Level 0
Level 0
T I M E D
A B S
S T O P
←
0 0 0 0 0
H O U R S
→
A B S
S T O P
←
0 0 0 0 0
H O U R S
→
SER
VICE
7. SERVICE
Adjust the ABS-system
Select ABS mode, Advanced
The following instructions only applies to a granulator
with electrical cabinet “Advanced”.
>Page 2:18 “Electrical cabinet, Operating panel”.
1. Read page 7:5 “General rules, Adjust the ABS-sys-
tem”.
2. Stop the granulator. >Page 5:1 point 1–2.
3. Start “Level 1”. >Page 7:6.
4. Select ABS mode: The ABS mode is selected by
changing the current setting on the display on top of
the electrical cabinet. Refer to figure (F) or (G).
a) Change the values / the parameters by pressing the
edit-buttons “Up” or “Down”.
b) Confirm by pressing the OK-button.
5. Press the edit-button “Right” until “Level 1” is
terminated and the “Level 0” message “Timed ABS”
or “ABS” appears. Refer to figure (H) or (J).
Start “Level 1”
The following instructions only applies to a granulator
with electrical cabinet “Advanced”:
1. Read page 2:19–2:22 Advanced, “Level 0” and “Level
1” messages
2. Stop the granulator. >Page 5:1 point 1–2.
3. Press the edit-button “Right” until the password
message appears. Refer to figure (E).
4. Press the edit-button “MOD”.
5. Enter the password (1212).
6. Confirm by pressing the OK-button.
7. “Level 1” is initiated and a message appears. Refer to
figure (F) or (G).
(A) = Edit-button “Up”
(B) = Edit-button “Right”
(C) = Edit-button “MOD”
(D) = OK-button
(E) = Password message, Level 0
(F) = Level 1, “Timed ABS” is selected
(G) = Level 1, “Automatic ABS” is selected
(J) = Level 0, “Timed ABS” is selected
(H) = Level 0, “Automatic ABS” is selected