Chapter 4. Commissioning the DeviceMaster UP
DeviceMaster UP PROFINET CbA User Guide
: 2000409 Rev. D
- 43
Changing the IP Address
•
The
Status
column in PortVision Plus displays
ON-LINE
.
6.
through 4 for each device that you intend to change the IP address for and all devices that
are interconnected the changed devices.
4.11.2. Changing the IP Address
This procedure describes how to change or initially configure the IP address for a DeviceMaster UP.
1.
From the
Server Configuration
page, click
Configure Network
. The
Edit Network Configuration
page
appears.
2.
Change the IP address information as required for your site.
Note:
You also have to restore the original PROFINET CbA number in the
PROFInet No
box if you selected
Reset port(s) to factory setting
in the previous procedure.
3.
Click
Save
. The
Configuration Updated
message appears.
4.
Click
Reboot
.
5.
Verify that the network connection for the DeviceMaster UP is functioning properly.
•
When lit, the amber
Status
LED on the device indicates the device is fully powered and has completed
the boot cycle.
Note:
The
Status
LED flashes for approximately 15 seconds while booting. When the bootloader
completes the cycle, the LED has a solid, steady light.
•
When lit, the red
Link/Act
LED indicates a working Ethernet connection.
•
When lit, the red
Duplex
LED indicates full-duplex activity.
•
When lit, the red
100
LED indicates a working 100 MB Ethernet connection (100 MB network, only).
6.
Verify that the change is successful by one of the following methods:
•
Type the new IP address for the device in your browser’s
Address
box.
•
Open PortVision Plus and click
Scan Network
. Verify that the new IP address for the device appears in
the list.
7.
through 6 for each device for which you want to change the IP address and/or PROFINET
CbA number.
4.11.3. Changing the IP Address in SIMATIC iMap
You can change the IP address for a DeviceMaster UP in SIMATIC iMap after initial configuration. Use
PortVision Plus to initially configure the IP address (above).
1.
Start SIMATIC iMap. Select
Start > Programs > Component based Automation > SIMATIC iMap
or double-
click the
iMap
icon on the desktop.
2.
Select
Project > Open
and click the library in which you want to import the PROFINET CbA component.
The filename must have a
.cpb
extension. When the library name appears in the
File
name box click
Open
.
Note:
The file name drop-down list contains the most recently opened SIMATIC iMap projects.
3.
If necessary, select the device in the
Net View
screen.
4.
Select
Edit > Properties...
.
Содержание DeviceMaster Up
Страница 1: ...PROFINET CbA User Guide ...
