33
Chapter 6
IP Routing
The IP routing function is disabled by factory default. To enable the IP routing
feature of the CT-510, enter the
MAIN/CONF/SYSTEM
menu, and select
Router
in the Operation Mode field (also described in Section 4.1.3). Then
you can configure the RIP, static route, and ping test functions that are
explained in this chapter.
6.1 RIP
Configuration
Step 1
Enter the
MAIN/CONF/ROUTING/RIP/GENERIC
menu.
Step 2
There are two fields on the menu. Enter a parameter in each field.
Mode: Select
Enabled
.
Auto Summary: Select
Enabled
if you use RIP version 1.
Step 3
Hold down the Ctrl-S keys to save the parameters.
The RIP function is now enabled. The default RIP parameter for each interface
is RIPv1. In this default mode, the CT-510 can operate normally without other
adjustments. If you want to configure advanced RIP functions, perform the
following procedure:
Step 4
Enter the
MAIN/CONF/ROUTING/RIP/INTERFACE/ATM
menu.
Step 5
Enter an ATM interface leaf menu (ATM 1 to ATM16), e.g.,
MAIN/CONF/ROUTING/RIP/INTERFACE/ATM/ATM1.
Step 6
Enter a parameter in each field.
Mode: Select
Enabled
Version: RIP version 2 or Version 1
Authentication:
1. None:
No authentication code is required.
2. PlainText:
An authentication code is required. You should
also fill in the
Authentication Code
field to assign a
password.
3. MD5:
An authentication code is required. You should also fill
in the
Authentication Code
field to assign a password.
Poison Reverse:
1. Enabled:
To enable the Poison Reverse
2. Disabled:
To enable the Splitting Horizon
Authentication Code: To key in the password for authentication
Step 7
Hold down the Ctrl-S keys to save the parameters.
Note that RIP is also available for LAN
Содержание CT-510
Страница 1: ...CT 510 ADSL Router User Manual Version A3 0 June 3 2003 261028 002...
Страница 66: ...65 QUIT...
