Comtrend Corporation CT-510, Руководство пользователя

Страница: 16 / 69

15
3.2 How to access CT-510
Three methods are available to access the device. You can choose from
console, Telnet, or Web. Any of the methods can be used to access, configure,
operate or monitor the device. Below shows how to get accessed to the
device.
3.2.1 Console
Your console PC should be installed with VT-100 emulation program, such as
Telix or HyperTerminal 5. Before you manage the system, verify all the
connections are made correctly.
Step 1
Start a standard VT-100 program such as Telix from the local
terminal and set the console parameters as follows:
Baud rate: 9600
Parity: none
Data bits: 8
Stop bit: 1
Flow control: none
Step 2 Initially, the console password check function is disabled; therefore,
you will not be prompted to enter a password. After the session
parameters are set up, as shown in Step 1, press any key to display
the following message:
“Press ESC key to enter console mode configuration”.
Step 3 Press the ESC key to display the main menu.
Step 4 You can start operating this device now. General configuration
procedures are described in Section 3.2.
Step 5 You can assign either a LAN IP address (proceed to Step 6) or WAN
IP address (proceed to Step 7) that is needed to access the device
through Telnet or through the Web.
Step 6 To change a LAN IP address, enter the MAIN/QC/LAN menu.