Comtech EF Data MBT-5000, Руководство пользователя по установке и эксплуатации

Страница: 18 / 138

MBT-5000 L-Band Up/Down Converter System MN-MBT5000
Introduction Revision 4
1–2
External interface connectors are located on the rear panel of the MBT-5000 chassis. External
equipment, e.g., a modem, is connected to each internal converter module via a standard, off-
the-shelf coaxial cable. A coaxial cable is also used to connect the output for each module to RF
equipment either at the same location or at the antenna location.
When configured with the redundancy option, the system may contain two diode “OR-ed”
internal power supplies for increased reliability and microprocessor-based Monitor and Control
(M&C) functionality.
Figure 1-2 depicts the operational schematics for typical MBT-5000 L-Band Up/Downconverter
System single thread (standalone) and redundant applications. For more information about the
MBT-5000’s use in redundant applications, see Appendix B. MBT-5000 REDUNDANCY
OPERATION .
MBT-5000 Single Thread (Standalone) Application
MBT-5000 Redundant Application (Single LNA Application shown)
Figure 1-2. MBT-5000 Operational Schematics