Pearl
– installation instructions
Electronic push button cabinet lock
Pearl
—
Installation
instructions:
KEYPAD version
9
KEYPAD version
To reset the
User Code
to the factory
default
1234
follow the steps on page
5 to enter programming mode.
There is a
10
second programming time
limit between each step. If Pearl times
out or error is made, programming
will end and you will need to enter
programming mode again.
1. Place Pearl into programming
mode (see page 5).
2. Type
8888
and then press the
(enter) button.
3. If successful, the
green
indicator
light will illuminate for 1 second.
Continue programming or press
9
and
then
(enter) to exit programming.
The
Supervisor Code
memory location
is called
Slot 01
and the first
User
Code
is called
Slot 02
.
Any additional User Codes reside in
memory slots 03-20.
To add a user code without specifying a
memory slot (03 -20), follow the steps
on page 5 to enter programming mode.
User codes must be 4 to 8 digits in
length and
must
be different from
all existing codes (including Slot 01
Supervisor & Slot 02 User codes).
There is a
10
second programming time
limit between each step. If Pearl times
out or an error is made, programming
will end and you will need to enter
programming mode again.
1. Place Pearl into programming
mode (see page 5).
2. Press
410
and then press
(enter).
3. Type the new user code and
press
(enter)
4. Retype the new user code and
press
(enter).
5. If successful, the
yellow
indicator
light will illuminate.
Continue programming or press
9
and
then
(enter) to exit programming.
Reset User Code to Factory Default 1234
(Does not apply to Single Use Mode)
Add User Without Specifying Memory Slot
