Pearl
– installation instructions
Electronic push button cabinet lock
Pearl
—
Installation
instructions:
KEYPAD version
5
KEYPAD version
Follow the directions below to unlock
and lock the Pearl.
To operate the Pearl:
To
unlock
, type a valid code,
press
(enter) and rotate
knob clockwise 90°.
To
lock
, rotate knob 90°
counter clockwise.
To enter programming mode you
must know the supervisor code. The
default supervisor code is
12345
.
Once in programming mode, multiple
changes can be made prior to exiting
programming.
There is a
10
second programming time
limit between each step. If Pearl times
out or an error is made, programming
will end and you will need to enter
programming mode again.
1. Lock must be in the
locked
position
prior to entering programming mode.
2. Type supervisor code and press
(enter).
Rotate the knob to the
unlocked
position and press and hold
(enter) for
3
seconds (
yellow
indicator light will illuminate).
3. With the
yellow
indicator light
illuminated, programming can begin.
Programming – Introduction continued
Pearl Programming Mode
