Pearl
– installation instructions
Electronic push button cabinet lock
Pearl
—
Installation
instructions:
KEYPAD version
11
KEYPAD version
The
Supervisor code
memory location
is called
Slot 01
and the first
User
code
is called
Slot 02
.
The additional user codes reside in
memory slots 03-20.
To delete a user code from a specific
memory slot (03 -20), follow the steps
on page 5 to enter programming mode.
There is a
10
second programming time
limit between each step. If Pearl times
out or an error is made, programming
will end and you will need to enter
programming mode again.
1. Place Pearl into programming
mode (see page 5).
2. Press
401
, then press
(enter).
3. Type memory slot to be vacated
followed by
(enter) (for memory
slots 03 - 09, you must type leading
“0” – e.g. “07” for slot 7)
4. Retype memory slot to be
vacated followed by
(enter).
5. If successful, the
yellow
indicator
light will illuminate.
Continue programming or press
9
and
then
(enter) to exit programming.
This feature shows the number of
times the lock has been operated. The
number of operations are displayed in
yellow light blinks and separated by a
green blink to determine the next value.
Example; yellow, yellow, yellow, green,
yellow, yellow, green, yellow, green,
yellow, green would equal 3211 lock
operations.
There is a
10
second programming time
limit between each step. If Pearl times
out or an error is made, programming
will end and you will need to enter
programming mode again
4. Place Pearl into programming
mode (see page 5).
a. To display number of lock
operations Type
60
and
then press
(enter).
OR
b. To reset to zero type
61
and then press
(enter).
Continue programming or press
9
and
then
(enter) to exit programming.
Delete User From Specific Memory Slot (03 – 20)
Display Number of Lock Operation
