Pearl
– installation instructions
Electronic push button cabinet lock
Pearl
—
Installation
instructions:
KEYPAD version
6
KEYPAD version
To change the user code, follow the
steps on page
5
to enter programming
mode.
The factory default user code is
1234
(User codes must be 4 to 8 digits in
length.)
There is a
10
second programming time
limit between each step. If Pearl times
out or an error is made, programming
will end and you will need to enter
programming mode again.
1. Place Pearl into programming
mode (see page 5).
2. Press
1
and then press
(enter).
3. Type the current user code and
press
(enter).
4. Type the new user code and
press
(enter).
5. Retype the new user code and
press
(enter).
6. If successful, the
green
indicator
light will illuminate for 1 second.
Continue programming or press
9
and
then
(enter) to exit programming.
To change the supervisor code,
follow the steps on page
5
to enter
programming mode.
The factory default supervisor code is
12345
(supervisor codes must be 4 to
8 digits in length.)
There is a
10
second programming time
limit between each step. If Pearl times
out or an error is made, programming
will end and you will need to enter
programming mode again.
1. Place Pearl into programming
mode (see page 5).
2. Press
2
and then press
(enter).
3. Type the current supervisor code
and press
(enter).
4. Type the new supervisor code
and press
(enter).
5. Retype the new supervisor code
and press
(enter).
6. If successful, the
green
indicator
light will illuminate for
1
second.
Continue programming or press
9
and
then
(enter) to exit programming.
Pearl features a reset code which will restore
the default supervisor code and user code.
Pearl was shipped with reset stickers – one
should be attached to the back of the Pearl, and
the extra sticker should be saved in a safe and
secure location for future reference.
To restore the factory default supervisor and
user code, type the Reset Code assigned to the
Pearl and press
(enter).
Changing the User Code
Changing the Supervisor Code
