3. DEFAULT SETTINGS
After removing the rear panel
of the device, the following
factory default settings can
be modified by relocating the
jumpers (black plugs) located
on the base panel.
3.1 Modifying the Switching Sensitivity
The switching sensitivity of the thermostat can be selected or
adjusted by the uppermost jumper.
The factory default switching sensitivity (the difference between
the adjusted temperature and the temperature measured when
the device is switched on or off) is ± 0.2°C that can be modified to
± 0.3°C by relocating the plug onto the left and central pins.
3.2 Changing the Unit of Measurement of the
Displayed Temperature
The unit of measurement of the temperature shown on the
LCD display can be selected and set by the central jumper.
With factory default settings the display shows the temperature
in °C (Celsius) which can be modified to °F (Fahrenheit) by
relocating the plug onto the left and central pins.
3.3 Changing the Displayed Temperature
The temperature(s) to be shown on the LCD display can
be selected and set by the bottommost jumper.
With factory default settings the display shows the
currently measured room temperature value, while the notice
“
ROOM
” appears in the bottom right corner of the display. The
adjusted temperature is visible only during the adjustment
process (for approximately 15 seconds). By relocating the
plug onto the left and central pins the displayed temperature
- 5 -
