Compaq TruCluster Server AA-RHGWB-TE, Руководство пользователя

Страница: 193 / 320

Table 8–3: Hardware Components Used to Create the Configuration Shown
in Figure 8 — 5 (cont.)
Callout Number
Description
9 199629-002 or 189636-002 (1.8-meter cable)
10
341102-001 terminator
a The maximum length of the BN38C (or BN38D) cable on one SCSI bus segment must not exceed 25 meters.
b The maximum length of the BN37A cable must not exceed 25 meters.
c The maximum combined length of these cables must not exceed 25 meters.
8.4 Preparing the TZ885 for Shared SCSI Usage
The TZ885 Digital Linear Tape subsystems combine a cartridge tape drive
(TZ88) and an automatic cartridge loader. The TZ885 uses a removable
magazine.
The TZ885 uses a five-cartridge (CompacTape IV) minitape library
(magazine) with a 200-GB capacity (compressed). It is capable of
reading/writing at approximately 10.8 GB per hour.
As with any of the shared SCSI devices, the TZ885 SCSI IDs must be set
to ensure that no two SCSI devices on the shared SCSI bus have the same
SCSI ID.
The following sections describe preparing the TZ885 in more detail.
8.4.1 Setting the TZ885 SCSI ID
To set the TZ885 SCSI ID from the Operators Control Panel (OCP), follow
these steps:
1. Press and hold the Display Mode push button (for about five seconds)
until the SCSI ID SEL message is displayed:
SCSI ID SEL
SCSI ID 0
2. Press the Select push button until you see the desired SCSI ID number
in the display.
3. Press the Display Mode push button again.
4. Issue a bus reset or turn the minilibrary power off and on again to cause
the drive to recognize the new SCSI ID.
8.4.2 Cabling the TZ885 Tape Drive
The TZ885 is connected to a single-ended segment of the shared SCSI
bus. It is connected to a differential portion of the shared SCSI bus with a
DWZZA-AA or DWZZB-AA. Figure 8–6 shows a configuration of a TZ885
Configuring a Shared SCSI Bus for Tape Drive Use 8–13