Compaq StorageWorks HSZ70, Руководство по установке, Страница: 63 / 168

Creating Your Storage Configuration with the CLI 6-7
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: HSZ70 Solutions Software V7.7 for Novell NetWare - PCI Comments:
Part Number: AA-R8JUE-TE File Name: g-ch6 Creating Your Storage Configuration with the CLI.doc Last Saved On: 5/17/00 9:16 AM
The controller displays information similar to the following example:
Controller:
HSZ70 ZG73101263 Firmware V73Z-0, Hardware H01
Not configured for dual-redundancy
Device Port SCSI address 7
Time: NOT SET
Host port:
SCSI target(s) (0, 1, 2, 3, 4, 5, 8, 9)
Preferred target(s) (0, 1, 2, 3, 4, 5, 8, 9)
TRANSFER_RATE_REQUESTED = 20MHZ
Host Functionality Mode = B
Command Console LUN is disabled
Cache:
128 megabyte write cache, version 4
Cache is GOOD
Battery is Good
No unflushed data in cache
CACHE_FLUSH_TIMER = DEFAULT (10 seconds)
NOCACHE_UPS
Mirrored Cache:
Not enabled
Extended Information:
Terminal speed 9600 baud, eight bit, no parity, 1 stop bit
Operation control: 00000004 Security state code: 7022
Configuration backup disabled
HSZ70>
Establishing Connection with a PC
To establish a connection between your PC and controller, you must use a
communications program. Follow these steps to make the connection:
1. Start a communications program on your PC (Hyperterminal).
\Start\Programs\Accessories\Hyperterminal
2. Set the communications program to use the serial port that is connected
to the controller.
3. Set the communications parameters to:
■
8 bits
■
9600 baud
■
1 stop bit
■
No parity