Compaq StorageWorks HSZ70, Руководство по установке, Страница: 107 / 168

Installing Upgrades to Your RA7000 Subsystem 8-21
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: HSZ70 Solutions Software V7.7 for Novell NetWare - PCI Comments:
Part Number: AA-R8JUE-TE File Name: i-ch8 Installing Upgrades to Your RA7000 Subsystem.doc Last Saved On: 5/22/00 2:23 PM
Configuring a Single Controller
Configuring a single controller RA7000 Subsystem involves specifying SCSI
target IDs for the controller, and if desired, changing the default settings of
other controller parameters. For additional information, refer to:
■
DIGITAL
TM
StorageWorks HSZ70 Array Controller HSOF Version 7.0
Configuration Manual (EK–HSZ70–CG)
■
DIGITAL
TM
StorageWorks HSZ70 Array Controller HSOF Version 7.0
CLI Reference Manual (EK–HSZ70–RM)
To configure a single controller:
1. Choose SCSI target IDs to establish addresses through which the host
can address the controller. You can specify up to eight SCSI target IDs.
Valid SCSI target IDs include 0-15. To set the SCSI target IDs, type:
HSZ70 > SET THIS_CONTROLLER ID = (N,N,N,N,N,N,N,N)
where (N,N,N,N,N,N,N,N) represents the SCSI target IDs selected between 0-15.
The controller displays information similar to the following example:
warning 4000: A restart of this controller is required before all the
parameters modified will take effect
%CER--HSZ70>>--13-JAN-1996 04:39:25 (time not set)—Restart of this
controller-required
Restart of the controller required
HSZ70 >
Although the CLI indicates that a restart of the controller must occur for the
changes to take effect, do not restart the controller until after you make all of
your changes to the controller configuration.
2. In addition to setting the SCSI target IDs for the controller, you can
change other controller parameters described in Table A-3 from default
to other setting options. To change any of the controller parameters
listed in Table A-3, use command syntax similar to that shown in Step 1.
HSZ70 > SET THIS_CONTROLLER ID = (N,N,N,N,N,N,N,N)
replacing the ID = (N,N,N,N,N,N,N,N,) with another parameter and valid setting, for
example:
HSZ70 > SET THIS_CONTROLLER PROMPT = “RA7000> ”