17
ICRI
LOCAL
HANDSET
The handset can be used as a local incident command radio or a troubleshooting device. Up to
250’ of cable maybe added to the cable length.
Setting up the handset
1.
Plug the handset into the jack labeled “HANDSET”. When connecting the handset, make
sure to align the flat side of the handset connector with the orange dot on the handset
jack.
2.
The audio level to the handset speaker can be adjusted by the rotating the volume knob
above the jack. Counterclockwise decreases the listening level, and clockwise increases
the listening level.
3.
Set the audio level to mid position.
4.
The handset microphone is enabled when the push-to-talk bar on the side of the handset
is depressed and held down.
Disconnecting the handset
1.
To remove the handset for storage, push inward on the handset connector and turn
counter clockwise to release the locking mechanism.
2.
Then pull the connector straight out of the jack. Hold the barrel of the connector rather
than the cable.
FIGURE 10: LOCAL HANDSET CONNECTED TO ICRI-2PE
