12
Use an AC source to power the ICRI
This power supply consists of two parts: the three-prong AC power cable and an AC to DC
converter with an interconnect cable.
NOTE: The AC supply must not be used where the cables or converter can become wet.
1.
Connect the power cord to the converter and to the DC source (110-120V, 60Hz).
2.
Connect the adapter’s plug to the jack on the ICRI, labeled POWER. Tighten locking
screw; it is important that the connector be firmly seated against the jack so that good
electrical contact is made.
NOTE: Align the plug’s “keyway” with the jack’s “key” before attempting to insert the plug.
3.
To release, loosen the locking screw and gently remove the connector.
NOTE: DO NOT remove the power cable by pulling from the cable.
FIGURE 4: AC POWER ADAPTOR, CHECK +/-
FIGURE 5: AC POWER SUPPLY, VIEW 2
