ADCP-90-516 • Rev B • April 2019
Page 8
© 2019, CommScope, Inc.
Figure 5. FL2000 Storage Panel 5-Inch Recess Rack Mounting Option (Top View)
4. Align the left side mounting bracket holes to the corresponding holes in the rack and
secure the panel to the rack using #12-24 screws (provided).
5. Align the mounting holes in the right side of the panel with the corresponding holes in the
rack, and secure the panel to the rack using # 12-24 screws (provided).
3.1.2
Flush, 1-, 2- or 4-Inch Recess Mount in a 19-Inch Rack
1. Remove the front cover of the storage panel by opening the cover approximately two
inches (5 cm), then lifting the cover from the hinges (see
).
2. Remove the VCG from the left side of the storage panel and install the
narrower
VCG
from the optional flush mount kit.
3. Attach the adjustable mounting bracket to the side of the VCG, positioned either at the
front (for flush mounting), or one or two inches back depending on the recess required.
(See items shown in dashed lines at the left side of
4. Attach the chassis mounting bracket (from the optional Flush Mount Kit) to the right side
of the storage panel with the same amount of recess as the mounting bracket attached in
. (See right side of
.)
5. The storage panel must be positioned on the equipment rack so any cross-connect or fiber
optic terminal (FOT) patch cords can enter the storage panel through the VCG at the left
side of the storage panel (see
).
Note:
To attach the storage panel flush, or with a one-inch, two-inch, or four-inch recess
from the front of the equipment rack, you will need the FL2000 Flush Mount Kit.
5 IN.
RECESS
5 IN.
RECESS
EQUIPMENT
RACK
EQUIPMENT
RACK
17108-A
