ADCP-90-516 • Rev B • April 2019
Page 9
© 2019, CommScope, Inc.
Figure 6. FL2000 Flush Mount Kit Rack Mounting Options (Top View)
6. Position the storage panel on the rack, then attach it by installing the supplied #12-24
screws through the slots in the mounting brackets attached to the VCG and the right side
of the storage panel.
3.1.3
19-Inch Maximum Mounting
The FL2000 19-Inch Maximum Mount Kit (not provided) allows the entire panel to be
contained within the frame footprint.
shows the panel and kit components.
Use the following procedure to mount the panel on the rack:
1. Remove the front cover of the panel by opening the cover approximately two inches (5 cm)
then lifting the cover from the hinges.
2. Unlatch and open the bulkhead panel.
3. Remove the VCG from the left side of the panel and in its place install the VCG provided
with the kit.
4. Position the panel on the rack.
5. Align the VCG mounting holes to the corresponding holes in the rack and secure the panel
to the rack using #12-24 screws (provided).
6. Align the mounting holes in the right side of the panel with the corresponding holes in the
rack, and secure the panel to the rack using # 12-24 screws (provided).
Note:
Removing the front cover and opening the bulkhead panel provides access to the
mounting holes at the right side of the panel (as viewed from the front).
EQUIPMENT
RACK
EQUIPMENT
RACK
17109-A
2 IN. RECESS
1 IN. RECESS
FLUSH
2 IN. RECESS
4 IN. RECESS
4 IN. RECESS
1 IN. RECESS
FLUSH
CHASSIS
MOUNTING
BRACKET
VERTICAL CABLE
GUIDE (VCG)
CHASSIS
MOUNTING
BRACKET
