18
5.4
Guide the prepared pigtail in the KTU. Make sure the kevlar
yarns do not entangle the fibers.
5.5
Close the KTU.
5.6
Slide the inner part to the left as much as possible by pulling
the jacket and kevlar at the same time.
Cut the excess kevlar leaving 5-10 mm.
In case of 2 pigtails
5.8
Guide the prepared pigtails in the KTU. Make sure the kevlar
yarns do not entangle the fibers. Keep the kevlar from each pigtail
separated.
5.7
In case of 2 pigtails/KTU; identify 1 of the fibers with a
marking pen.
5.9
Slide the inner part to the left as much as possible by pulling
the jacket and kevlar at the same time.
Cut the excess kevlar leaving 5-10 mm.
5.10 In case of less kevlar (typically this means pigtail
diameter < 2,3 mm): wrap the kevlar to ensure a good strain relief.
