Removing Glass Door
If replacement of glass is necessary, the
entire assembly, glass and frame, must be
replaced. If glass is broken, wear gloves and
tape remaining fragments onto frame.
1. Remove screen/rod assembly from
fire
-
box, push rod either left or right and then
down and forward. Set assembly aside.
2. Lift up on latches to unlock. There are
two on top of
fi
rebox and two below
fir
ebox that hold glass door in place (see
Figure 42).
3. While holding glass door to prevent it from
falling and causing injury, remove the
five
screws from hinge located on left side of
door frame assembly (see Figure 42).
4. Remount new frame at hinge with
fiv
e
new screws before closing door. This will
ensure seating of gasket.
5. Close glass door frame. Lock latches by
placing bar under tab on door and pushing
down and back on latch (see Figure 42).
6. Replace screen/rod assembly by revers-
ing step 1.
7. Replace louvers by reversing procedure
under
Removing Louver Panels
, page 23.
FIREPLACE INSTALLATION
Continued
Figure 42 - Removing/Replacing Glass
Door
Lock
Unlock
Glass Frame
Assembly
Screw
Hinge
Latch
INSTALLING OPTIONAL BRICK
LINER MODEL BL32D
WARNING: If
fireplace
has
been running, turn off and un-
plug
fireplace.
Let
cool
before
installing brick line
r
.
This brick liner kit is optional. You may pur-
chase brick liner from your local retailer or
see page 37.
CAUTION: Always handle
brick
pa
nels with two hands
.
Do not
force
brick
panels
into
place.
E
xcess
ive fo
rce
will brea
k
brick panels.
1. Remove top and bottom louvers to allow
access to door latches.
2. Unlock door latches and open glass door.
See steps 1 and 2 of
Removing/Replacing
Glass Door
, page 23.
3. If installing brick liner in new
fi
replace,
go to step 4. If installing brick liner in an
existing
fireplace,
carefully remove logs,
lava rock and ember material.
4. Remove three screws from deflector
shield on the inside top of
firebox
. Set
shield and screws aside.
5. Install rear brick panel
first.
Rest bottom
edge of panel on back edge of grate (see
Figure 43).
6. Install left side brick panel by sliding it
between grate and side of
fi
rebox (see
Figure 43).
Figure 43 - Installing Rear Brick Panel
Rear Brick
Panel
Cleaning Glass Door
See
Cleaning and Maintenance
on page 31.
