Comfortflame.US.com
900563-00NC
13
INSTALLATION
Continued
INSTALLING OPTIONAL BLOWER ACCESSORY
NOTICE: The firebox identification label (including
model number, serial number, clearances, etc.) is
located in the right side screen pocket area on the
front of the firebox. See Figure 24, page 20.
NOTICE: If a log set is installed in the firebox, discon-
nect log set from gas supply and remove from firebox.
Contact a qualified service person to do this.
Note: Appearance of firebox may vary depending on model.
There is a blower accessory option for use in this fireplace. Blower
accessory model is BK for all louvered models only. Model BK is a
rotary squirrel cage type blower with magnetic attachment and vari-
able speed control.
Wiring Instructions
1. Remove electrical cover plate with bushing from fireplace by
removing 2 sheet metal screws as shown in Figure 12.
2. Slide power source wiring through electrical bushing opening
and electrical cover plate and make all necessary connections.
3. Slide all wiring connections in electrical housing as shown in
Figure 12.
4. Secure electrical cover plate with screws previously removed.
Note: Electrical housing and cover plate have sharp edges. Wear
protective gloves.
Figure 11 - Location of Knockout for Gas Line
Knockout
Chisel
Firebrick Side Wall
Remove
this Area
Side
View
Figure 10 - Installing Gas Line and Equipment Shutoff Valve
(Model May Vary From Illustration)
Knockout
Locations
(Knock Out
One Hole)
Gas Line Hole
Equipment Shutoff
Valves (Install One)
Figure 12 - Electrical Bushing
Electrical
Bushing
Electrical
Cover
Plate
Electrical
Housing
Wire Nut (3x)
(Not Supplied)
Outer Wrapper
of Fireplace
Electrical Cover
Plate and
Electrical Bushing
Fireplace Chassis
Ground
To Power
Source
Receptacle
(Supplied)
Power Source Wiring
(Not Supplied)
Prewired Receptacle
and Ground
Sheet Metal
Screws
