580A
www.comcast-sa.com
Operation Instruction.
I. Take out the insulator of the battery and charge the unused lithium
battery for 1.5hours before using the machine. While the charger green
light is on and the red light is off, the battery has been fully charged.
Insert the battery into the relevant handle position of machine. Turn on
power switch, and the indicator light (red light) will on with buzzer,
which means the machine is on.
II. Rotate and remove the six-hole circular cover of the fixed wire plate
in the middle of the fuselage, In the power-on mode, Put our
customized wire coil into the machine.
III. Take out and straighten the end of the wire (approx. 10-15cm), and
slowly insert the wire into the plastic mouth, until it is blocked. Put the
wire coil cover back and lock the lock buckle.
Attention: the wire would fail to be sent if the end of the wire is not
straightened.
IV. Hold the wire with two fingers and push it forward. Press the trigger
and send out the wire. Attention: keep your hands away from the jaw
when tying
V. Take out the high suitable insulation rod, and connect with the
battery insulation rod
VI. 6. Lift the fuselage and select the right line for construction.
VII. Put all the cables that need to be bundled into the binding grooves.
