InteliATS
NT
STD, SW version 2.0, ©ComAp – June 2010
53
IA-NT- STD-2.0-Reference Guide.pdf
oller, close the boot jumper and switch
•
r
cess
ns.
•
tus line and the
controller is blocked showing "Init" state. Use
C
ONTROLLER
->
R
ESET FROM
I
NIT STATE
menu
item to put the controller to normal operation. Be sure you have checked all setpoints before.
•
It may be required to switch off power supply of contr
on controller again. Follow the information windows accordingly.
After programming is finished (it may be required to power off controller, open the boot jumpe
and power it on again) open configuration window and perform the configuration pro
manually. There is no compatibility of the configuration between different firmware versio
In some cases the "wrong setpoints" message can occur in the DDE server sta
C
AUTION
!
Check the statistic value
s after firmware upgrade. Readjust the values if necessary.
IL-NT-RD Wiring
IL-NT-RD can be connected to InteliATS
NT
, InteliLite
NT
or InteliDrive Lite controller
RS485 communication line. It is possibl
via RS232 or
e to connect only up to two remote displays to one master
ing different communication COMs. It is not supported to connect two or more
one master
nnected. It
ntrollers address 1 to 32 and later on COM2 from address 1
to 32. Remote display tries two communication speeds 38400 bps and 56000bps.
Detecting…” on screen and progress bar below counts from 0 to
prox. 10-15 seconds. Than is 5 seconds pause and process continues
llers, not supported application, or controllers that are not properly
mote display can not connect with master controller:
o uppo ed type of controller connected (Eg. IGS-NT, ID-DCU, IC-NT, IGS-CU, etc.)
d firmwa
ller
tab
roller
4. Wrong settings o
in master controller
g connectio
Direct RS232 connection
HW module:
IL-NT-RS232
Master controller settings:
ControllerAddr = 1..32
COM1 Mode = DIRECT
Up to 2 meters:
Reco
to use our standard AT-LINK cable.
controller, if they are us
remote displays to one communication line, eg. RS485. It is possible to monitor only
controller from one remote display at the time.
Connection process
Remote display after power on automaticaly starts to search for any master controller co
starts to search on COM1 from master co
During this process is displayed text “
100%. This process takes ap
again until compatible master controller is found.
Not supported types of contro
comunicating are skipped during the search.
Controller type selection
IL-NT-RD automatically detects controller type.
Troubles with connection
There are few reasons why re
1. N t s
rt
2. Not supporte
re in master contro
3. Configuration
le error in master cont
f setpoint COMx Mode
5. Wron
n, wiring, communication fail
mmended
