15
13. ADJUSTING THE SQUEEGEE INCLINATION
During working operation, the rear rubber is slightly tilted backwards (by about
5mm) in a uniform way for its whole length. If it is necessary to increase the
bend of the rubber in the central part, you must tilt the squeegee backwards,
rotating the adjuster (4) anticlockwise. To increase the bend of the rubber at the
sides of the squeegee, rotate the set screw clockwise.
14. ADJUSTING THE SQUEEGEE HEIGHT
The height of the squeegee must be adjusted on the basis of the state of wear
and tear of the rubber. To do this, you must loosen or tighten the screw (1) on
the rear of the squeegee command arm.
15. RECOVERY TANK
Check the cap of the drainage tube (on the rear of the machine) is correctly closed.
ATTENTION: To avoid foam production, put a minimum
quantity of antifoam liquid in the recovery tank before starting to
clean
16. SOLUTION TANK / DETERGENT SOLUTION (VERSIONS WITHOUT CDS)
Proceed as follows to fill the solution tank:
1. Turn the key of the master switch anticlockwise to the “OFF” position.
2. Engage the parking brake.
1
