Page 30 of 39
INSTRUCTION MANUAL
SECT IO N 6
-
TEST LEVEL CALIBRATION
Rev050321
If the EM Clamp will be used for multiple test levels (1 Vrms, 3 Vrms, 10 Vrms,
etc.), calibration should be performed at the highest test level. Calibration
data for the lower test levels can then be calculated as shown in Equation
5.
For instance, if the calibration was performed for a test level of 10 Vrms, and
the offset is needed for a test level of 3 Vrms:
The offset factor calculated above can then be applied to the calibration
results at the higher test level using Equation 6.
Distributed by: Reliant EMC LLC, +1 408 916
‐
5750, [email protected], www.reliantemc.com
