Columbia CEG-C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 12 / 32

12
ELECTRICAL WIRING
SEE PAGE 14 FOR WIRING DIAGRAMS AND COMPONENT CODING
!
WARNING
Boiler, when installed, must be electrically
bonded to ground in accordance with
the requirements of the authority having
jurisdiction or, in the absence of such
requirements, with the National Electrical
Code, ANSI/NFPA 70.
Install a fused disconnect switch between
boiler and meter at a convenient location.
Electrical wiring must conform with the latest revision
of the National Electrical Code, ANSI/NFPA No. 70 and/
or local authority having jurisdiction.
THERMOSTAT INSTALLATION
• Thermostat should be installed on an inside wall
at least two feet from a non-insulated or outside
wall, approximately four feet above the fl oor.
• NEVER install a thermostat on an outside wall.
• Do not install a thermostat where it will be
affected by:
A. Drafts
B.
Hot or cold pipes
C. Sun light
D. Lighting fi xtures
E. Television
F.
Fireplace or chimneys
• Check thermostat operation by raising and
lowering thermostat as required to start and stop
the burners.
• Instructions for the fi nal adjustment of the
thermostat are packaged with the thermostat
(adjusting heating anticipator, calibration, etc.).