Coltri Sub MCH 13/ET, Инструкция по эксплуатации

Страница: 46 / 92

46
Putting the machine out of operation
and dismantling the machine
PUTTING PUTTING PUTTING PUTTING PUTTING THE MA THE MA THE MA THE MA THE MACHINE OUT OF OPERA CHINE OUT OF OPERA CHINE OUT OF OPERA CHINE OUT OF OPERA CHINE OUT OF OPERATION TION TION TION TION
AND AND
AND AND AND DISMANTLING TH
DISMANTLING TH
DISMANTLING TH DISMANTLING TH DISMANTLING THE MACHINE
E MACHINE
E MACHINE E MACHINE E MACHINE
10 10
10 10 10
10.1 10.1 10.1 10.1 10.1 Instr Instr Instr Instr Instr uctions f uctions f uctions f uctions f uctions for pr or pr or pr or pr or pr olong olong olong olong olong ed mac ed mac ed mac ed mac ed mac hine standstills hine standstills hine standstills hine standstills hine standstills
This chapter provides instructions to be followed for long machine standstills or for the dismantling of
the same.
10.1 Instructions for prolonged machine standstills ................................................................ 46
10.2 Disposal of waste products ................................................................................................ 46
10.3 Dismantling the machine ................................................................................................... 47
WARNING
Before carrying out any procedure on the machine, read Chapter 4, “Precautions for use and maintenance”
with care.
If the compressor is not to be used for prolonged periods, remove the active carbon cartridge from the
strainer filter.
Run the compressor idle for a few minutes to drain off any residue condensate. Stop the compressor,
remove the intake filter, start up the compressor again spraying a few drops of oil into the intake hole so
that a light film of lubricant is sucked in and penetrates the internal parts of the compressor.
Stop the compressor and refit the intake air filter. Clean the external parts and try to remove any saline
humidity and oily deposits. Protect the compressor from dust and water by storing it in a clean, dry
place.
Turn the machine off using the general switch (position “0”) and remove the power plug.
Carry out a general cleaning operation on the machine and all its components.
When using the compressor, special waste products are produced. It must be remembered that waste
from industrial processes, agricultural, artisan and commercial activities and service industries cannot
be disposed of together with normal urban waste either because of their quality or quantity.
Old or obsolete machinery is also to be considered as special waste.
Special care must be taken with the disposal of worn active carbon filters which, being a waste product
that cannot be disposed of together with normal urban waste, must be dealt with in compliance with the
laws in force in the country where the compressor is installed.
10.2 10.2 10.2 10.2 10.2 Disposal of waste products Disposal of waste products
Disposal of waste products Disposal of waste products
Disposal of waste products