Coltri Sub MCH 13/ET, Инструкция по эксплуатации

Страница: 11 / 92

11
The pumping unit has the task of producing compressed air at high pressure (200-300 bar) and purifying
it by means of the decantation and filtering systems until it reaches a level of purity equal to or higher
than the limits set by the standards DIN 3188 - UNI EN 132 - CGA/E, or to increase the pressure of the
gas inhaled (only inert - non-explosive gases).
This unit consists of the following components (Fig. 5-6):
5
The intake air contains a certain degree of humidity according to atmospheric conditions. During the
compression and subsequent cooling, the humidity condenses and together with the particles of lubricating
oil forms a milky white emulsion that precipitates into the separators.
The compression diagram is included in chapter 13.
6
Technical description
2 . 2 2 . 2
2 . 2 2 . 2 2 . 2 Description of the pump unit Description of the pump unit
Description of the pump unit Description of the pump unit
Description of the pump unit
N° Description N° Description
1 Intake filter 12 2 nd stage safety valve
2
1 st stage head
13
Monobloc
3
2 nd stage head
14
Filter-holding bracket
4
3 rd stage head
15
Fan
5
1 st stage cylinder
16
Oil cap
6
2
nd
stage cylinder
17
Final condensate separator
7
3
rd
stage guiding cylinder
18
Condensate separator between stages
8
1 st -2 nd stage cooling pipe
19
Condensate discharge connection
9
2 nd -3 rd stage cooling pipe
20
Maintenance valve
10 Final cooling pipe 21 Pipe-fastening bracket
11 1 st stage safety valve 22 3 rd stage or final safety valve
Table 1