SmartLF Cx+40 Instruction Manual
Page 6 of 12
1.3
Removing / Replacing The Main Board.
1. Open rear access panel as
described in chapter
“1.2
Opening Access Panel.
” page
4.
2. Disconnect CIS ribbon cables
by first, carefully, releasing the
locking slide and then sliding
the cable out from the
connector and out through the
ferrite held on the panel.
Repeat this to all 5 ribbon
cables.
3. Disconnect the power Cable
PSU DC O/P from PSU and the
motor cable.
4. Disconnect the display board
ribbon cable from the Main
board.