Colortrac SmartLF Ci 40, Руководство по обслуживанию

Страница: 51 / 101

Page 51
Ci Scanner Service Manual
8. Insert all the cables into
the correct sockets.
Making sure they are all
pressed fully home to
ensure a good connection.
9. Rotate the control board
bracket back into the
position and replace the
M3 Pan Head screws,
making sure the large flat
washers are on the side of
the screw heads. Before
tightening the screws, push
the control board bracket
completely to the back of
the scanner, then tighten
the screws up.
10. Replace the Lid Cover
Extrusion Sub-A as in
Chapter 11.3. If the Lid
Cover Extrusion Sub-A
catches on the control
board bracket, remove the
Lid Cover Extrusion Sub-A
again, loosen the M3 Pan
Head screws holding the
control board bracket
down, and move the
control board bracket
forward slightly, (or left /
right if necessary), re-
tighten the screws and refit
the Lid Cover Extrusion
Sub-A.