4 Electrical settings
The winder control C9100 controls the winders motorcurrent and the breakcurrent depending on
the dancers position. This position is sensed without contact in five steps with optical sensors
placed at the rear side of the winder control p.c.board. Six connectors are used to connect the 24
volt supply voltage, the motor and break wires respectively. Figure 10 shows the component side
of the p.c.board:
Figure 10: Winder control
The winder control board carries seven jumper blocks for the motor and break current
adjustment. Three jumpers (
WIND
,
TORQUE
and
DANCER
) are used for the motor currentt.
The following table shows the jumpers and their function.
Motor-jumpers
Function
DANCER
Direction of action of dancer roller
TORQUE
Torque
WIND
Rewinder/Unwinder
24V
GND
MOTOR
BREAK
WIND
TORQUE
DANCER
5999.554-01A 16.08.2001 WM
Page 18 / 26
