2 Introduction
2.1 General information
This Technical Manual describes design and function of the Powered Winder C9100. In addition
to the Operating Instructions, it contains the settings and notes necessary to get optimum use of
the Winder C9100. The descriptions of the electrical and mechanical assembly also help for
quick error analysis and trouble-shooting.
We recommend to replace p.c.boards always as complete units returning them to Collamat
Stralfors or its representative for repair to be sure that the high quality standard of the Winder
C9100 can also be guaranteed after any repair.
Special characteristics of the Winder C9100:
resistant to wear
rugged
quick change-over to other labelling tasks
high performance
SMD-technology
3 The Winder C9100
The Winder C9100 must be installed by trained personnel considering the following national
specific regulations:
Prevention of accidents
Noise suppression
Construction of electrical and mechanical systems
3.1 Prevention of accidents
When installing and connecting the C9100 monitor and labeller pay attention that the signal and
power cables cannot become stumble obstacles. Lay the cables according to the national safety
regulations. Signal cables must not be placed in close proximity to power cables.
3.2 Noise suppression
For radio interference suppression the C9100 labeller and monitor are shielded according to the
CE directives. Only cables approved by Collamat Stralfors are allowed to be used to connect the
monitor to labeller and mains. Additional peripherals have to be connected only to the mains
socket of the monitor. These devices must be approved by Collamat Stralfors.
5999.554-01A 16.08.2001 WM
Page 5 / 26
