Label length
The
Label length
function is used to adjust the length of the label manually or
automatically.
LABEL LENGTH
Auto adjust
Manual adjust
Auto adjust
When adjusting the label length automatically, the measuring has to be started by the
ENTER
key. The adjustment can be aborted by depressing the
ESC
key
.
After starting
the adjustment, the paper web is pulled forward by 2 gaps to measure the label length.
If no gap is detected, an error message appears and the label length is set to 100 mm.
AUTO ADJUST
LABEL LENGTH
Auto adjust done
Adjust Label length
Length : 100 mm
with [ENTER] Key
User level:
programmer
Operating Mode:
STOP
Note:
The measured label length should only be considered as an approxima-
te value. When using this value a fault message may appear, because
due to mechanical slippage the traction roller may cover a distance
exceeding the label length. When the labeller stops are exceeded an
error message appears.
Normally after automatic measurement the double or triple label length
is entered by hand. The advantage is that the labels not existing on the
backing paper are compensated.
Manual adjust
When adjusting the label length manually, the value is entered by hand. Entering can
be aborted by depressing the
ESC
key. This function is advantageously used after the
auto automatic length measurement. (The label length should be entered twice or three
times longer than the actual label length. Thus labels missed on the backing paper web
can be compensated.)
LABEL LENGTHSCANNER
Length : 100 mm
programmer
STOP
User level:
Operating mode:
5999.530-01B 13.08.98 WM
Page 17 /
49
