Error #5 Label stock
Error #6 Rewinder full
Cause:
The label stock of the unwinder is empty or the rewinding disk of the rewinder is full.
Solution:
Replace empty paper roll or remove backing paper roll from rewinder disk.
Error #7 LSC-adjustment
Cause:
Adjustment of label scanner not possible. The scanner is defective or it is scanned on
label instead of gap, or the backing paper is not transparent enough.
Solution:
Shift gap under label scanner and adjust it again. Possibly exchange defective
scanner.
Error #8 Nonstop mode
Cause:
One of the labellers has an error. The nonstop mode does not function correctly. The
error can be triggered by all error messages.
Solution:
Eliminate the error on the labeller.
Nonstop reset
at
both monitors
.
Error #9 Label too long
Cause:
A leading label edge could not be scanned within the entered label length. The cause
of this error can be as follows:
Missing labels on the paper web
Slippage of the traction unit or loss of steps of the stepper motor due to hits on the
paper web or too high frictional force
Value of label length is entered too short
Predispensing greater than label length
Value of label length shorter than suppression of label scanning
Error of label scanning
Solution:
The following items may be helpful:
Enter in general double or three times the value of the label length
Correct predispensing
Adjust suppression of label scanning
Check label scanner and possibly clean it
Use unwinder with double dancer roller
Reduce friction force of entire paper web
5999.530-01B 13.08.98 WM
Page 42 /
49
