COLENTA PrintlineProcessor 56 RA, Инструкция по эксплуатации

Страница: 27 / 40

AN 06/2003
page
11.3 HOW TO CHANGE A PROGRAMME
To change the programme, use the following steps:
Press
5
one time, you will get:
NOTE: In case there is a media inside the processor, the display will show you
"Busy processing" - now you need to wait until the current cycle is finished.
To change the program, use
6
to move the cursor to P1.
Press
7
to change the number of the program. P1 wil change to P2, P3, until P8 and
at least PSL (Sleepmode) There are 8 working programs and 1 Sleep program. With
6
,
move the cursor to Use and confirm that with
7
.
Use
4
to jump back to the main page.
After working (in the evening and through the weekend)
the processor can be set to Sleepmode. This will prevent
cristalization on the rollers.
Use the above mentioned procedure to do that.
More informations regarding this, see the pages 29,30.
23
Start P1 Use
Rep Monitor
Start PSL Use
Rep Monitor
Processor switch off
in 03 sec Sleep mode!
Run after xxmin
.... when in Sleep mode.