Cole Parmer PolyStat CC1080, Руководство пользователя

Страница: 19 / 32

- 17 -
9. Operation
9.1 Start

Turn the excess temperature protection to a setting above the desired
operating temperature 13 .

Start the circulator using the mains switch 1 .
This causes:
Display 6 to briefly show the device identification and then the version num -
ber of the operating system software, e.g. “0.11”. Next the temperature at the
control sensor is displayed.
Display 5 shows which one of the four adjustable set values is currently acti-
vated (set temperature “S” or one of the fixed temperatures “ F1”, “ F2” ,
” F3" (see 9.4).
The pump motor starts and circulates the bath liquid.
Cooling is switched on using switch 27 located on the front of the unit. The
compressor starts with a slight jerk. Cooling is activated only if cooling is
actually required.
9.2 Heating control lamp
Display 4 lights up when the heater is activated (set temperature is higher
than the actual temperature).
display 4 lights up constantly during the heating up phase,
display 4 flashes on and off during the control phase.
Display 4 does not light up if heating is not activated (set temperature is
lower than the actual temperature).
1
13
5
6
4
27