15 \ USER OPERATION MANUAL:
Cole-Parmer Basic Ductless Fume Hood Series
Exhaust Plenum Installation
(RX and NANO Fume Hoods Only)
1.
Place the plenum in the correct orientation on the
metal top panel of the fume hood.
2.
Insert the provided self-tapping screws into each hole
in the plenum housing.
3.
Use a drill with a nut driver to tighten down the
plenum.
Waste Chute Installation
(RX Fume Hoods Only)
1.
Locate the blanking panel currently installed on the
side of the fume hood.
2.
Remove the mounting screws in each corner of the
blanking panel and disconnect the panel from the
fume hood.
3.
Align the waste chute on the outside of the fume
hoods, matching the mounting holes with the
existing holes in the side of the fume hood.
4.
Insert the mounting screws and tighten down evenly
(screw heads can be oriented to the inside or outside
of the fume hood).
Balance Enclosure Assemly
(RX and NANO Fume Hoods Only)
1.
Stand up the rear baffle; it will pivot from an attached
hinge located on the left and right side panels.
