12 \ USER OPERATION MANUAL:
Cole-Parmer Basic Ductless Fume Hood Series
10. Reinstall the filter door and secure the locks
using the barrel key.
Final Assembly
Monitair and Autocal Equipped Units
11. To install the airflow sensor, remove the clear
panel on the inner right sidewall. Open the
screw cap on the outside of
the enclosure, undo the screw and nut and set
aside. DO NOT DISCARD!
12. Remove any tape on the airflow sensor which is
used to protect the sensor wires. Install the
sensor by attaching to the enclosure with the
screw and nut.
13. If not already installed, slide the polypropylene
spill tray into the enclosure. The side with the
extended handle/lip should go toward the back
of the hood.
Warning - Once installed do not remove spill tray
from enclosure. Do not use tray like a drawer. Do
not push down, lean on or apply excessive force.
Tray is only intended to sit over existing work
surface.
