Cognex MVS-8000 Series, Руководство по оборудованию

Страница: 31 / 86

1 MVS-8600 Installation
MVS-8600 Hardware Manual 31
Loadable Software I/O Configurations
The MVS-8600 supports different combinations of trigger, strobe, and encoder pinouts,
depending on the currently loaded software I/O configuration. See your Cognex
software package’s documentation to learn how to load I/O configurations onto the
MVS-8600.
Each I/O configuration corresponds to a different cable that you use to connect the
MVS-8600 to the I/O connection module, as summarized in Table 3.
Take note of the following points about the information in Table 3.
• The cables in Table 3 connect to the Hirose HR10 connector on the MVS-8600
faceplate, and to the DB-26 connector on the I/O connection module.
• The LEDs on the top panel of the I/O connection module illuminate differently for
each cable when power is applied, to show which jacks are enabled by that cable.
• The default I/O configuration option for both VisionPro and CVL software is 1.
Software
I/O option
Cable to I/O
connection
module
Camera configuration
Encoder
type
MVS-8602,
MVS-8602e
only
1
(default)
300-0539
One area scan n/a
Two area scan n/a yes
One line scan LVDS
One line scan, one area scan LVDS yes
Two line scan
(shared encoder) LVDS yes
2 300-0540
One area scan n/a
One line scan TTL
Two area scan n/a yes
Two line scan TTL x 2 yes
One line scan, one area scan TTL yes
3 300-0538 Two line scan LVDS x 2 yes
Table 3.Software I/O configuration options